how to drill a hole in concrete to set fence post

How Many Bags of Concrete for a Fence Post? | HGTV

Fast-setting concrete is ideal for installing fence posts since it doesn't need to be mixed in a bucket or a wheelbarrow. Once you’ve finished digging your post holes, add about three to four inches of gravel into the bottom and compact it using a post or a 2x4. Then, set your post in place and use a level to ensure that it’s perfectly 【Get Price】

How to Install a Fence Mounted to Concrete (A Better Approach)

When installing a fence on an existing concrete pad, some fence installers prefer to core drill through the concrete and set posts the traditional way – embedded in concrete underground. Using a rented core drill, you can drill a hole through your concrete slab for each fence post.【Get Price】

Fence Post Hole Sizes and Digging Fence Post Holes | DIY Doctor

If you need to install a fence post or other post type, find out how deep and wide the hole should be in order for it to remain in place and upright. Find out the exact size hole you need to dig for the size of post you're using, what tools you need to use to dig fence post holes and what the best technique is to save you both time and 【Get Price】

How to Install Fence Posts in Rock | Hunker

Set steel T-posts in rock by drilling a hole slightly larger in diameter than the T-post. Knock the spade off the bottom of the T-post. Drop the bottom end of the post in the hole. If it is snug, tap the post down with a hammer. If it is loose, fill in around the post with cement.【Get Price】

How to Drill into Concrete (DIYer's Guide) - Bob Vila

That durability can be quite the obstacle, however, for homeowners trying to mount an art installation on a concrete feature wall, drill a hole to set a fence post at the end of the driveway, or 【Get Price】

How to Dig Post Holes and Set Fence Posts - Outdoor Essentials

How to Set Fence Posts in Concrete 6 - Pour in gravel. After you have your post hole dug to the proper depth, pour in a few inches of gravel in the bottom of the hole. This will help with drainage. 7 - Place and brace your post. Set your post in the hole. Check for plumb and make sure the front of the post is just touching the string line. This 【Get Price】

Setting Posts without Mixing | QUIKRETE: Cement and Concrete Products

Dig post hole so diameter of the hole is 3 times the width of the post (i.e., the hole for a 4” wood post should be about 12 inches wide). The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).【Get Price】

How to Set a Fence Post in a Concrete Driveway - Charlotte Dreamscapes

You'll need a hammer drill capable of drilling into concrete. If you do not own one, you can rent one from a tool rental shop. Using your string line to mark where the fence face will be, go over a couple of inches to find where the center of the post should be. Mark that spot or go ahead and drill a hole there. I used a 3/4" drill bit.【Get Price】

How to Pour Concrete for Fence Posts in Cold Weather | Hunker

The holes for the fence posts must be deep and wide enough to allow you to pour concrete in. Once the concrete dries, it acts as a solid support beneath the ground. Pouring concrete for fence posts is more difficult in cold weather, as freezing temperatures can damage the concrete as it sets up.【Get Price】

How to Drill Into Concrete - The Seven Trust

Replace the drill in the pilot hole, ensuring that the drill is perpendicular surface. Start the drill and push forward with firm but not heavy pressure. Run the drill at a slow to medium speed and pull the drill out periodically to help remove concrete dust from the hole.【Get Price】